SIGNAL CONDITIONERS Isolated Signal Conditioner Plug-in Type【174】

Dual-channel loop-powered isolator that takes the power from its input current loop.

Receives two DC current or voltage signals and outputs a signal proportional to the result of an arithmetic operation (addition, subtraction, multiplication or division).

Holds an output signal using external hold input.

Holds an output signal using external hold input. (with LED indicators)

Compensates for variations in temperature, pressure, or differential pressure for accurate flow calculation.

Accepts non-linear DC current or voltage input and provides linearized output. Up to 21 breakpoints can be configured for segment approximation. These breakpoints and I/O ranges can be changed using a PC.

Converts DC current or voltage signals with polarity into absolute value signals.

Amplifies DC current or voltage input signals, converts them into split range control signals, and provides isolated dual output. Available in two output variants: V-shaped and parallel characteristics.

Converts thermocouple inputs into commonly used DC signals. PC programmable for I/O configuration.

Converts RTD inputs into commonly used DC signals. PC programmable for I/O configuration.

Converts millivolt signals from sensors or other devices into commonly used DC signals. PC programmable for I/O configuration.

Accumulator that converts DC current or voltage signals into pulse train signals.

Converts DC current or voltage signals into PWM signals.

Converts DC current or voltage signals into high DC current signals.

Socket for the MS3700 Series

Connecting cable used for downloading configuration software for programmable signal conditioners

Precision resistor (250Ω/50Ω) with lead wires. It is available in either fork or ring type terminal lugs for M3.5 screws.

Converts thermocouple inputs into commonly used DC signals.

Converts RTD inputs into commonly used DC signals.

Converts millivolt signals from sensors or other devices into commonly used DC signals.

Converts DC current or voltage signals into commonly used DC signals.

Compares the levels of DC current or voltage signals with two or four set-points and outputs two or four independent isolated relay contact closure signals.

Powers a two-wire transmitter and converts its 4 to 20mA signals into commonly used DC signals. This model can also be used as an isolator.

Powers a two-wire transmitter and converts its 4 to 20mA signals into commonly used DC signals. This model can also be used as an isolator.

Converts pulse train signals from flow sensors and the like into commonly used DC signals.

Detects changes in the resistance of potentiometric sensors and converts them into commonly used DC signals.

Calculates the rms values of AC current signals from a CT and converts them into commonly used DC signals.

Calculates the rms values of AC current signals from a PT and converts them into commonly used DC signals.

Continuously monitors the insulation resistance of an inactive motor and indicates the insulation status at three levels: GOOD, ALARM, and FAILURE.